Filter
Top Products
2
SAFETY INSTRUCTIONS
For best results position your receiver away from radiators or other heat sources. Leave a space
of at least 3 cm all round the receiver for ventilation making sure that the ventilation holes are
not obstructed.
This receiver is intended for use in a domestic environment only and should never be operated
or stored in excessively hot, humid or damp conditions.
Make sure no objects or fluids enter the housing through the ventilation slots. Should this
happen, disconnect your receiver from the mains and consult your retailer.
For cleaning, use a damp chamois leather, never use any abrasive cloth, sponge or cleaner.
When connecting or disconnecting cables to the receiver always ensure the receiver is
disconnected from the mains.
Please wait before connecting your receiver - read on.
Mains connection
Before connecting the receiver to the mains, check that the mains supply voltage corresponds to
the voltage printed on the type plate of the receiver. If the mains voltage is different, consult your
dealer.
Important
This apparatus is fitted with an approved moulded 13 A plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS1362 3A, A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and appropriate plug
fitted in its place. If the mains plug contains a fuse, this should have a value of 3A.
If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A.
Note : The severed plug must be destroyed to avoid a possible shock hazard should it be
inserted into a 13A socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with the following code:
- BLUE - "NEUTRAL" ("N")
- BROWN - "LIVE" ("L")
1. The BLUE wire must be connected to the terminal which is marked withg the letter "N" or
coloured BLACK.
2. The BROWN wire must be connected to the terminal which is marked with the letter "L" or
coloured RED.
3. Do not connect either wires to the earth terminal in the plug which is marked by the letter "E"
or by the safety earth symbol l or coloured green or green-and-yellow. Before replacing the
plug cover, make certain that the cord grip is clamped over the sheath of the lead - not
simply over the two wires.
1
1