Philips DVDR3330H DVR User Manual


 
English
59
Setup Menu Options (continued)
Feature settings (underlined options are the factory default settings)
Access Control This is to prohibit viewing of discs that had exceeded the limits you set.
Before you can set the parental level or country, you must set a four-digit
pin code. Press OK to access.
{ Enter Code } When doing this for the  rst time, use the
numeric keypad 0-9 on the remote control to
enter any four-digit you prefer. You must enter
the same pin code a second time to con rm it.
If you forget your four-digit pin code, press
STOP
four times to revert to default pin code
‘0000’ and enter any four-digit you prefer.
{ Level } It works only on the DVDs with parental level
assigned to the complete disc or to certain scenes
on the disc. Use keys to select a rating level
from 1 to 8. The ratings are country-dependent
(‘1’ is considered material that is least offensive
and ‘8’ is most offensive). DVDs that are rated
higher than the level you selected will not play
unless you enter your four-digit pin code.
To disable parental controls and allow all discs to
play, select ‘0ff’.
{ Set Country } The Parental control levels depend on the
country in which the DVD was manufactured.
Therefore, it is necessary to select a geographic
area as the playback limitation level.
Status Display Display the information about the current state of the recorder. Press OK
to select:
The current operating information will be
displayed for few seconds.
Turn off the status display.
Resume With this feature, you can resume playback of the disc from where it last
stopped. This applies to the last 20 DVDs and Video CDs you played.
Press OK to select:
Turn on auto resume mode.
The disc will always start from the beginning
when you load a disc or start playback.
Low Power Standby This is an energy saving mode. Press OK to select:
When you switch the recorder to standby mode,
the display panel will turn blank to save power.
Note: When this mode is active, automatic
SAT(satellite) recording is not possible.
Clock will display on the recorder’s display panel
when switching off to standby mode.
Adapt Disc Menu This option is only visible when you load a DVD±R/±RW that was
recorded in another recorder. Make sure that the recorder is in stop
mode with no disc menu displayed on the screen, see page 51.
PBC Enable This option is only visible when a VCD/SVCD is in the disc tray.
Parental Level
Enter Code
Level: Off
Set Country
[ ] [ ] [ ] [ ]
Austria
Press SETUP to save and exit.
dvdr3300H_eu_eng_17223d.indd 59dvdr3300H_eu_eng_17223d.indd 59 2005-10-19 4:16:43 PM2005-10-19 4:16:43 PM