Philips DVDR3330H DVR User Manual


 
English
65
Problem Solution
Troub le shooti ng (continued)
The recorded DVD cannot be
played back on another DVD
player.
The message ‘Disc contains
unknown data’ appears.
Picture is fuzzy and
brightness varies when
copying DVD Video discs or
prerecorded video cassettes.
‘No Signal’ appears on the
recorder’s display panel.
The message ‘Timer overlaps
existing timer’ appears.
The message ‘This will clear
the time shift bar’ appears.
– If a recording is too short, it is possible that a DVD player
cannot detect it. Observe the following ‘minimum recording
times’. Recording mode : {HQ} – 5 minutes, {SP} – 10 minutes,
{SPP} – 13 minutes, {LP} – 15 minutes, {EP} – 20 minutes, {SLP}
– 30 minutes, {SEP} – 30 minutes.
This message may appear if you insert a disc that was not
 nalised. DVD±Rs that have not been  nalised are very sensitive
to  ngerprints, dust, or dirt. This may cause problems during
recording. To use the disc again, do the following :
1) Make sure that the surface of the disc is clean.
2) Press OPEN/CLOSE on the recorder to open the disc tray.
3) Insert the disc but do not close the tray.
4) Hold down button number {5} on the remote control until
the tray closes. This recorder will start the repair process.
5) If the disc is recovered, the Picture Index screen will appear.
Observe the following:
– Error during recording: The title may be missing.
– Error while changing the title/index picture: The original title/
index picture may be visible.
– Error while  nalising: The disc appears not to have been
 nalised.
This happens if you try to copy DVDs or video cassettes that
have been copy-protected. Even though the picture on the TV is
 ne, the recording on the recordable DVD is faulty.
This interference is unavoidable with copy-protected DVDs or
video cassettes.
The recordable DVD has a limited recording lifetime, use a new
disc for recording.
No signal received. Check that the cable is plugged in  rmly.
If a recording is made from a video recorder, change the
tracking on the video recorder.
This recorder may not be able to recognise the video input
signal if this signal is poor or does not comply with relevant
standards.
The timer recording overlaps with another timer recording.
If you ignore this warning, the programmed recording with the
earlier start time will start  rst
Change the information for one of the two recordings.
Delete one of the two recordings.
The requested action requires the time shift buffer (temporary
HDD storage) to be cleared. All contents not marked for
recording will be deleted.
dvdr3300H_eu_eng_17223d.indd 65dvdr3300H_eu_eng_17223d.indd 65 2005-10-19 4:16:45 PM2005-10-19 4:16:45 PM