Filter
Top Products
Learning commands from other remote controls (Learn mode)
35
6 On the remote control,
press and hold
either the Left or the Right button.
In the Device menu, while holding down the Left or Right button, tap a
device.
The remote control flashes the word
device
.
7 While
device
is flashing, press and hold the correct button on the source
remote.
When the remote control learns the command,
OK
flashes briefly on the
display. The remote control beeps and then returns to Learn mode.
If after a few seconds the remote control has not learned the command
successfully, it buzzes, and
FAIL
appears briefly on the display. See
“Troubleshooting” on page 33.
8 Repeat steps 4 through 7 to program other Device menu items.
9 When you’re done, return to Use mode to test the new commands: Tap
to open the Mode menu, and then tap .
CHOOSING A NEW DEVICE WITHOUT SWITCHING THE SOURCE
On occasion, you might want to send commands to a device without switching
the source. For example, you might want to rewind the VCR while you’re
watching a DVD. For instructions, see “To switch devices without affecting the
source” on page 23.
With Device menu
open, hold down
the Left or Right
button ...
... tap the menu
item you want to
program.