Filter
Top Products
Troubleshooting
Common
Symptom Cause Action (See)
Power doesnt turn on.
The unitdoesnt operate.
Leads andconnectors areincor-
rectly connected.
Confirm oncemore thatall connections are
correct.
The fuseis blown. Rectify thereason forthe fuseblowing, then
replace thefuse. Bevery sureto installthe
correct fusewith thesame rating.
Noise andother factors arecausing
the built-inmicroprocessor tooper-
ate incorrectly.
PressRESET. (Page12)
Operation withthe remotecon-
trol isntpossible.
The unitdoes notoperate cor-
rectly evenwhen theappropriate
remote controlbuttons are
pressed.
The remotecontrol operationmode
is incorrect.
Switch tothe correctremote control mode.
(Page 17)
The remotecontrol codeis incor-
rect.
Make surethe remotecontrol selection
switch settingand codetype setting arethe
same. (Page 62,Page 64)
Batterypower islow. Load newbattery.(Page 13)
Some operationsare prohibited
with certaindiscs.
Check byusing anotherdisc.
Playback isnot possible. Thedisc isdirty. Clean disc.(Page 74)
The loadeddisc isa typethis unit
cannot play.
Check whattype thedisc is.
Non compatiblevideo systemdisc
is loaded.
Change toa disccompatible toyour video
system.
No soundsare heard.
The volumelevel willnot rise.
Cables arenot connectedcorrectly. Connect thecables correctly.
Withsome discs, 96kHz outputis
prohibited.
Switch theoutput settingto 48kHz. (Page 61)
The unitis performing still, slowmo-
tion or frame-by-frame playback.
There isno soundduring still,slow motion or
frame-by-frame playback.
There isno picture. The parkingbrake cordis notcon-
nected.
Connect aparking brakecord, andapply the
parking brake.
The parkingbrake isnot applied. Connect aparking brakecord, andapply the
parking brake.
The icon
is displayed,and op-
eration isnot possible.
The operationis prohibitedfor the
disc.
This operationis notpossible.
The operationis notcompatible
with thediscs organization.
This operationis notpossible.
The picturestops (pauses)and
the unitcannot beoperated.
Readingof data hasbecome impos-
sible duringplayback.
After pressingg once,start playbackonce
more.
There isno sound.
Volume levelis low.
The volumelevel islow. Adjust thevolume level.
The attenuatoris on. Turn theattenuator off.
There isaudio andvideo skip-
ping.
The unitis notfirmly secured. Secure theunit firmly.
Additional Information
En
71
Appendix
Additional Information