Filter
Top Products
Preparation
05
16
En
Preventing the plasma television from
falling over
After installing the stand, be sure to take special care to ensure
that the plasma television will not fall over and is stabilized to both
the wall and rack.
Stabilizing on a table or rack
Stabilize the plasma television as shown in the diagram using the
plastic bands and screws provided with the optional stand.
Note
• To stabilize the plasma television on a table or rack, also use
commercially available wood screws that have a nominal
diameter of 4 mm and that are at least 20 mm long.
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left
and right sides.
Using a wall for stabilization
1 Attach falling prevention bolts (hooks) to the plasma
television.
2 Use strong cords to stabilize it appropriately and firmly to
a wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Use hooks, cords, and fittings that are available on the market.
Recommended hook: Nominal diameter 8 mm, length 12 mm
to 18 mm.
Caution
• A table or rack with adequate strength should always be used
to support the plasma television. Failure to do so could result
in personal injury and physical damage.
• When installing the plasma television, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes, or of
accidents.
• If you do not take these precautions, the plasma television
could fall down and cause injury.
• The screws, hooks, cords, and other fittings that you use to
secure the plasma television to prevent it from overturning will
vary according to the composition and thickness of the surface
to which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.
M
O
N
I
T
O
R
O
U
T
D
I
G
IT
A
L
D
I
G
I
T
A
L
O
U
T
OUT
O
P
T
I
CA
L
O
P
T
ICAL
SUB
W
O
O
F
E
R
20 mm min.
4 mm
8 mm to 15 mm
Screw
(M4 x 10 mm)
Wood screw
(commercially available,
4 mm x 20 mm min.)
Wood screw
Screw
D
I
G
IT
A
L
D
I
G
IT
AL
O
UT
OUT
O
P
T
I
C
A
L
O
P
TIC
AL
MO
NIT
OR
OU
T
D
I
G
I
T
A
L
D
I
G
IT
A
L
O
U
T
O
UT
O
P
T
I
C
A
L
O
P
TI
C
AL
S
U
B
W
OO
FE
R
M8
12 mm to 18 mm
1. Hook
2. Cord
Fitting