Pioneer PDP-428XDA Flat Panel Television User Manual


 
Preparation
05
17
En
Basic connections
Connecting the antenna
To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
For viewing both analogue and digital broadcasts, connect the
antenna cable to the ANT OUT terminal (antenna through out)
and ANT (analogue input) terminal.
Be sure to use the provided antenna cable.
For viewing analogue broadcasts only, connect the 75-ohm
coaxial cable (commercially available) to ANT (analogue input)
terminal.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma television.
Note
If the antenna is not connected correctly, the quality of reception
may be impaired. If images are not displaying correctly, check
whether the antenna connection is correct or not.
To view both analogue and digital broadcasts with a single
connecting cable, use the provided “loop” antenna cable. For
optimum picture quality, connect an antenna cable directly to a
single (either digital or analogue) antenna terminal.
Routing cables
Use the speed clamps as necessary to route the connecting
cables. The diagrams below show the location of the holes on the
rear of the display.
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma
television and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
Be careful not to subject any connecting cables to strain.
Note
Use the speed clamps as necessary.
(Rear view)
MONITOR
OUT
DIGITAL
DIGITAL
OUT
OUT
OPTICAL
OPTICAL
SUB
WOOFER
MONITOR
OUT
DIGITAL
DIGITAL
OUT
OUT
OPTICAL
OPTICAL
SUB
WOOFER
PDP-508XDA (rear view)
MONITOR
OUT
DIGITAL
DIGITAL
OUT
OUT
OPTICAL
OPTICAL
SUB
WOOFER
PDP-428XDA (rear view)
MONITOR
OUT
SUB
WOOFER
DIGITAL
DIGITAL
OUT
OUT
OPTICAL
OPTICAL
1
2