Filter
Top Products
21
BASIC OPERATIONS
FRONT PANEL FUNCTIONS
8 RESET button
Press to set the Projection Monitor to its initial mode.
Initial mode
Input selector: Set to TV.
TV channel: Remains at the last channel set.
VOLUME: Remains at the last setting.
MUTING: OFF
PICTURE
MODE: STD
Parameters: Set to 0.
PureCinema: OFF
COLOR TEMP: STD
3D Y/C LEVEL: 3
3D NR LEVEL: 3
SVM: HIGH
FLESH TONE: ON
BLACK ENHANCE: ON
SHARP EFFECT: ON
SOUND
MTS: MAIN
Parameters: Set to 0.
SURROUND: OFF
STABLE VOLUME: OFF
SCREEN
SCAN MODE: 1080i
MODE: NATURAL WIDE
CC: OFF
SYSTEM IN/OUT
SPEAKER: NORMAL
AUDIO OUT: FIXED
SYSTEM MODE: OFF
NOTE:
When this button is pressed while adjusting the MULTI-POINT
convergence, the MULTI-POINT convergence returns to the
initial mode.
9 INPUT 4 jacks
These inputs are for Video Movie and VCR. Use RCA-type pin
plug cords (the same as those used in Hi-Fi systems) and S-
VIDEO cords for connections. When the audio source to be
connected is mono, connect the source to the L-(MONO) jack.
CAUTION:
Do not press any operation button on the Projection Monitor
or the remote control unit while recording. Signals from the
MONITOR/TV OUTPUT jacks may be temporarily interrupted
when a button is pressed.
ATTENTION
The Projection Monitor will not function properly in the
following cases.
• An electrical discharge in the CRT.
• Lightning storms.
• High static electricity environment.
• Poor voltage regulation in the power source.
If the Projection Monitor does not operate properly, reset it as
follows:
1. Turn off the power of the unit with the 2 MAIN POWER
button.
2. After approximately 1 minute, turn on the power with 2
MAIN POWER button and 3 POWER (
STANDBY/ON)
button.
If the normal operation cannot be restored after the above
treatment, immediately unplug the power cord and call your
nearest PIONEER-authorized service center.
NOTES:
•
On rare occasions, an electrical discharge may occur inside the
CRT*. It makes a short, sharp pop and either no sound is
produced or the volume level changes by itself. The SPLIT screen
and SEARCH screen functions will be cancelled automatically if
an electrical discharge occurs when this function is engaged.
*CRT: Cathode-ray Tube
•
When an electrical discharge distorts the screen and the TV
power has been automatically shut off, it can turn on.
If you notice any abnormality of the screen, turn off the MAIN
POWER button for a few minutes then turn it on.
This is not a malfunction.
RESET
VOLUME INPUT 4
S
-
VIDEO L
-
AUDIO
-
RVIDEO
(MONO)
RESET
7 9
8
ARB1557A_En_020_025.P65 8/8/03, 18:1121