Filter
Top Products
81
VARIOUS FUNCTIONS
1
Set the mode switch to match the device
to which you want to preset the remote
control code
• Example: To select DVD/DVR.
2
At the same time, press the EDIT button
and number button 1.
3
Select the desired manufacturer.
• Select from the figure on page 82.
• Example: To select 006 (PIONEER) in the DVD/DVR mode.
REMOTE CODE SET UP
NOTES:
• To stop the EDIT mode in the middle, press the EDIT
button once more.
• If mode switch is switched while in EDIT mode, EDIT
mode will be canceled.
• After step 1 and step 2, if you do not press the
button for one minute (no operation), the EDIT
mode will be canceled.
• If the table on page 82 does not include your desired
manufacturer or the remote control code does not
work, you can make the memory learn its code by
the learning mode (see page 84).
• The initial code is “000” (PIONEER).
|\
LED will begin blinking.
• If the LED blinks rapidly when the number button has been
pressed, there has been an error. Input the number again.
• After setting, you can automatically use the remote control in
the usual manner.
To operate other manufacturers' audio/video units using this remote control
unit, remote control codes need to be input.
There are two methods of setting remote control codes
• For calling the other manufacturers' preset remote control codes to this
remote control unit
• For learning other manufacturers' remote control codes
RECALLING OTHER
MANUFACTURERS' PRESET REMOTE
CONTROL CODES
ARB1557A_En_081_091.P65 8/10/03, 09:3081