Filter
Top Products
3-18
GB
3-17
DIGITAL VIDEO RECORDER
GB
6
Alarm Record Setup
The following illustrates the intial setting of the ALARM RECORD SETUP menu.
① ALARM ENABLE
You shall select ON to start recording in the event of alarming and select OFF to prevent
recording in the event of alarming. If you set the ALARM ENABLE to ON and exit the menu,
the system will begin recording whenever alarm occurs. To force stop the recording during the
alarm recording, press and hold the STOP(
■) button for 3 seconds. Then, the recording by the
current alarm will be stoppted, and the alarm recording will not be performed for the next 5
seconds even if alarm occurs. To completely stop the alarm recording, go into the menu
within that 5 seconds to set the ALARM ENABLE to OFF. If no action is performed by the
user for 5 seconds, the system returns to the alarm recording mode. [ON/OFF]
② ALARM DETECT TYPE
Set to N. C. (Normally Close) when the alarm input is Active High, and set to N.O.(Normally
Open) when the alarm input is Active Low. [N.C./N.O.]
➂ ALARM BUZZER
Set to ON to have the system activate the Buzzer when a motion is deteced in the input
video or when alarm occurs, or set to OFF to keep the Buzzer inactive. [ON/OFF]
➃ MAIN ALARM TIME
Set the duration for which alarm recording is to be performed when a motion is detected in the
input video or when alarm occurs. The value can be set from 0 seconds to 5 minutes when you
set to OFF. If you set to AUTO, the alarm recording is performed only during when the alarm
signal is Active.
[5MINUTE/4MINUTE/3MINUTE/2MINUTE/1MINUTE/30SECOND/20SECOND/
10SECOND/AUTO/OFF]
➄ DISK END BUZZER
If set to ON, the Buzzer will sound when the HDD is full during the recording; if set to
OFF, the Buzzer will not sound. [ON/OFF]
➅ RECORD TIME MARK
If set to ON, the recording time will be displayed during playback; if set to OFF, it will not
be displayed. [ON/OFF]
➆ STATUS DISPLAY
Set the location on the screen where the time of recording will be displayed during
playback. Set to LEFT to display it on the bottom left of the screen, or set to RIGHT to
display it on the bottom right of the screen. [LEFT/RIGHT]
ALARM RECORD SETUP
ALARM ENABLE OFF
ALARM DETECT TYPE N.O.
ALARM BUZZER ON
MAIN ALARM TIME 10SECOND
PRE ALARM TIME LIMIT 2SECOND
POST ALARM TIME LIMIT OFF
MAIN ALARM PICTURE RATE 30.00FPS
MOTION DETECTION OFF
SET AREA & SENSITIVITY