Filter
Top Products
English
Recording settings
How to set 56
1
Display the <ALARM REC MODE SET> screen as
explained in "Displaying the recording settings
screen", and then turn the S-dial clockwise. (P39)
The "OFF" field of ALARM RECORDING starts
blinking.
2
Set the alarm recording.
1 Turn the J-dial to select ALARM RECORDING
selection, and then turn the S-dial twice
clockwise.
Selections:
OFF/ENABLED/AL-REC ON TIMER/AL-REC OFF
TIMER/OLY AL-RC ON TMR
2 Turn the J-dial to select the desired PICTURE
QUALITY, and then turn the S-dial twice
clockwise.
After the arrow symbol (=>) the number of alarms
that can be recorded is displayed.
Selections:
BASIC/NORMAL/ENHANCED/FINE/SUPER FINE
Example:
3 Turn the J-dial to switch AUDIO RECORDING
"ON", and then turn the S-dial twice clockwise.
The letter "A" is displayed in front of the recording
rate, and the number of alarms that can be recorded
is displayed after the "=>" symbol.
Example:
4 Turn the J-dial to select the recording pattern
(ALARM INTERLEAVE), and then turn the S-dial
twice clockwise.
Selections: ONLY/SW
☞ If ONLY is selected (Figure 1):
Live video will be recorded only from the camera
where the alarm was detected, until the alarm is
cancelled.
☞ If SW is selected (Figure 2):
Live video will be recorded alternately from the
camera where the alarm occurred and from all
connected cameras.
5 Turn the J-dial to select the REC RATE (example:
5), and then turn the S-dial clockwise.
Repeat the same procedure to set the DURATION.
3
Press the EXIT/OSD button.
The normal screen is displayed again.
• The letter "ALARM" and the number of alarm
recordings are displayed in the operation display.
• When an alarm is detected, the "ALARM" field starts
blinking.
☞ If consecutive alarms are detected on the same
channel, depending on the alarm retrigger setting,
they may be counted as one alarm. (P60)
G-1 Alarm recording settings
MENU
(J)
(S)
<ALARM REC MODE SET>
ALARM RECORDING : OFF
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ***
REC RATE: **** FPS, DURATION: ****
=> (01731 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->
7.ALARM REC MODE SET
2.RECORD SET
<MAIN MENU>
<RECORD SET>
=> (01387 ALARMS CAN BE RECORDED)
REC RATE: A 12.5FPS, DURATION: 20SEC
=> (01431 ALARMS CAN BE RECORDED)
11111111111111111111
Alarm detected
Alarm cancelled
Records the channel where the alarm was input until the
alarm is turned off
1 2 1 3 1 4 1 5 1 6 1 2 1 3 1 4 1 5 1 6
Alarm detected
Alarm cancelled
Records the channel where the alarm
was input and the other channels
alternately until the alarm is turned off
Alarm channel
Normal recording
02
EXIT/OSD
01-01-06 00:00:00 REC REPEAT EN A ALARM 0000
Alarm total
Alarm indicator