Filter
Top Products
228 Fibre Channel Interface Manual, Rev. D
12.13.6 Verify Error Recovery page (07h)
The Verify Error Recovery page specifies the error recovery parameters the target uses during the Verify com-
mand and the verify operation of the Write and Verify command.
Field definitions (listed alphabetically)
DCR (Disable Correction)
1 ECC correction will not be applied to the data even if correction is possible.
0 ECC correction will be applied if correction is possible.
DTE (Disable Transfer on Error)
The DTE bit is valid only when the PER bit is set to 1.
1 The disc drive terminates data transfer even for recoverable errors (the drive will transfer the data for the recovered
error before terminating the transfer).
0 Data transfer continues if recoverable errors are encountered. Recoverable errors are reported after all data has
been transferred.
Table 151: Verify Error Recovery page (07h)
Bit
Byte
76543210
Page descriptor header
01 0
Page Code (07h)
PS Reserved
1
Page Length (0Ah)
Verify error recovery parameters
2 00000
PER DTE DCR
Default Reserved EER
3 Default
Verify Retry Count
4 Default
Verify Correction Span (bits)
5 00000000
Default Reserved
6 00000000
Default Reserved
7 00000000
Default Reserved
8 00000000
Default Reserved
900000000
Default Reserved
10(MSB) 11111111
Default Verify Recovery Time Limit
1111111111 (LSB)
Default Verify Recovery Time Limit
Table
number
151
151