Filter
Top Products
Configuring the authentication order:
Select Remote -> Local or Remote Only from the drop-down menu and press Apply.
For more information on remote authentication order, see Setting the authentication order on page 57.
NOTE: Server Technology recommends NOT setting the authentication order to Remote Only until the LDAP has been
fully configured and tested.
Configuring LDAP groups:
Click on the LDAP Groups link at the bottom of the page.
Creating an LDAP group:
Enter a descriptive group name in the LDAP Group Name field. Up to 24 alphanumeric and other
typeable character (ASCII 33 to 126 decimal, spaces are not allowed) are allowed. Press Apply.
Removing an LDAP group:
Click on the Remove link in the Action column for the group to be removed and press OK on the
subsequent confirmation window.
Changing an LDAP group’s access privilege level:
Click on the Edit link in the Action column for the associated LDAP Group.
On the subsequent LDAP Group - Edit page, select Admin, User, On-only or View-only from the
Access Level drop-down menu and press Apply.
For more information on access privilege levels, see Changing a user’s access privilege level:
on page 17.
Granting or removing Environmental Monitoring viewing privileges:
Click on the Edit link in the Action column for the associated LDAP Group.
On the subsequent LDAP Group - Edit page, select Yes or No from the Environmental Monitoring
drop-down menu and press Apply.
Adding and Deleting outlet access:
Click on the Outlets link in the Access column for the associated LDAP Group.
On the subsequent LDAP Group - Outlets page, select or deselect outlets to be accessed by the LDAP
Group and press Apply.
Adding and Deleting outlet group access:
Click on the Groups link in the Access column for the associated LDAP Group.
On the subsequent LDAP Group - Groups page, select or deselect outlet groups to be accessed by the
LDAP Group and press Apply.
Adding and Deleting serial port access:
Click on the Ports link in the Access column for the associated LDAP Group.
On the subsequent LDAP Group - Ports page, select or deselect ports to be accessed by the LDAP Group
and press Apply.
TACACS+
The TACACS+ configuration page is used for setup and maintenance of all settings required to enable
TACACS+ support. For additional information and configuration requirements, see TACACS+ on page 63.
Enabling or disabling TACACS+ support:
Select Enabled or Disabled from the TACACS+ drop-down menu and press Apply.
Setting the TACACS+ server IP address:
Enter the IP address in the Host IP1 and/or Host IP2 address field and press Apply.
Setting the TACACS+ encryption key:
Enter a key and verify the new key the Encryption Key and Verify Encryption Key fields. Press Apply.
For security, key characters are not displayed.
20 • Operations Sentry PT22
Installation and Operations Manual