Filter
Top Products
Displaying Infeed information
The Show Infeeds command displays information about all infeeds. This information includes the
absolute and descriptive infeed names.
To display tower information:
At the Sentry: prompt, type show infeeds and press Enter.
Example
Sentry: show infeeds<Enter>
Input Input
Feed ID Feed Name
.AA HQ_1_Infeed_A
Displaying the Sentry firmware version
The Version command displays the Sentry firmware version.
To display the firmware version:
At the Sentry: prompt, type version and press Enter.
Performing a warm boot
The Restart command performs a warm boot of the Sentry.
NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this command.
To perform a warm boot:
At the Sentry: prompt, type restart and press Enter.
TCP/IP Administration
NOTE: A restart of the Sentry is required after setting or changing ANY TCP/IP configurations. See Performing a warm
boot on page 35 for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Sentry: prompt, type set ipaddress, followed by the IP address and press Enter.
Example
The following command sets the IP address to 12.34.56.78:
Sentry: set ipaddress 12.34.56.78<Enter>
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Sentry: prompt, type set subnet, followed by the subnet mask and press Enter.
Example
The following command sets the subnet mask to 255.0.0.0
Sentry: set subnet 255.0.0.0<Enter>
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the Sentry uses to access external
networks.
To set the gateway IP address:
At the Sentry: prompt, type set gateway, followed by the gateway IP address and press Enter.
Example
The following command set the gateway IP address to 12.34.56.1:
Sentry: set gateway 12.34.56.1<Enter>
Sentry Commander - PT40 Operations • 35
Installation and Operations Manual