Filter
Top Products
Displaying network configuration information
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP configuration information.
• IP address, subnet mask and gateway
• Enabled-disabled status of Telnet, SSH, HTTP,SSL and SNMP support
• Telnet, SSH, and HTTP port numbers
• HTTP authentication method and SSL access setting
• Network status
See Chapter 4: Advanced Operations on page 41 for more information on SNMP and Secure Proxy
To display network configuration information:
At the Sentry: prompt, type show network and press Enter.
Example
The following command displays the network configuration information:
Sentry: show network<Enter>
Network Configuration
IP Address: 12.34.56.78
Subnet Mask: 255.0.0.0
Gateway: 12.34.56.1
Telnet: Enabled Port: 23
SSH: Enabled Port: 65535
HTTP: Enabled Port: 80 Security: BASIC
SSL: Enabled Access: Required
SNMP: Enabled
Network Status
Link: Up
Speed: 100 Mbps
Duplex: Full
Negotiation: Auto
36 • Operations Sentry Commander - PT40
Installation and Operations Manual