Filter
Top Products
38
Safety Information
Power cord (mains lead)
Do not place the product where a piece of furniture or other heavy object could trap the
power cord (mains lead). Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your hands are wet as this could
cause a short circuit or electric shock. Never make a knot in the cord or tie it with other cords.
The power cords should be routed in such a way that they are not likely to be stepped on.
A damaged power cord can cause re or give you an electrical shock. Check the power cord
periodically to see if it is damaged. If it is damaged, please ask an approved service agent to
replace it.
For your own safety read following instructions carefully before attempting to
connect this device to the mains. This unit is designed to operate on a 220V-240V
AC – 50
Hz supply only. Connecting it to other power sources may damage it. Ensure
that the supply corresponds to the information on the rating label on the bottom
of the unit. This component system may be tted with a non-rewireable plug. If it is
necessary to change the fuse in a non-rewireable plug, the fuse cover must be retted.
If th e fuse cover becomes lost or damaged, the plug most not be used until a replacement, available
fr om the manufacturer, is obtained. It is important that the colour of the replacement fuse cover
corresponds with the colour marking on the base of the plug. If the plug needs to be changed
because it is not suitable for your socket, or it becomes damaged, it should be unplugged
then cut o and the fuse removed immediately. Please dispose of the plug safely and out
of reach from children. Under no circumstance should the cut-o plug be inserted into a
mains socket outlet due to high risk of
electric shock. Then t an appropriate
plug carefully following the wiring
instructions shown below.
Important
The wires in the mains plug should
be connected as shown in the
diagram. The colours of the wires
in the mains lead of the unit may
not correspond with the coloured
markings identifying the terminals in
your plug. Connect them as follows:
• The wire which is coloured
blue must be connected to the
terminal which is marked with the letter ‘N’ or coloured black.
• Thewirewhichiscolouredbrownmustbeconnectedtotheterminalwhichismarkedwith
the letter ‘L’ or coloured red.
• There should be no connection to the earth terminal of your plug.
If you use a 13 Amp (BS1363) plug, you will need a 5 Amp fuse.
• Themainsplugisthedisconnectdeviceandthereforemustremainreadilyoperable.