Sony PDW-1500 VCR User Manual


 
Chapter 8 Menus
106
8-4 Maintenance Menu
8-4 Maintenance Menu
8-4-1 Items in the Maintenance Menu
The maintenance menu includes the following items.
In the table, the underscored items are the factory default
settings.
For details about DRIVE MAINTENANCE, CHECK and
SERVICE SUPPORT, refer to the Maintenance Manual.
AUDIO CONFIG: items relating to audio control
Item Setting
METER HEAD ROOM Select the audio reference level (headroom).
–12dB,–16dB, –18dB, –20dB
(525(U)/525(J)-line modes)
–12dB, –16dB, –18dB, –20dB
, EBUL (625-line mode)
DATA LENGTH When “IMX50,” “IMX40,” or “IMX30” is selected in setup menu item 031, this selects the
audio quantization bit count and number of recording channels.
: 16 bits × 8 channels
24×4: 24 bits × 4 channels
Note
When item 031 is set to “DVCAM,” the setting is automatically fixed at 16 bits × 4 channels.
NON-AUDIO INPUT Select whether to handle digital audio signals as non-audio signals during recording.
Sub-item
1 tr1/tr2 audio
: Handle as audio signals.
data: Handle as non-audio signals.
2 tr3/tr4
3 tr5/tr6
4 tr7/tr8
INPUT LEVEL Set the upper limit for the signal level input to audio channels 1/3 or 2/4.
+4dB
, 0dB, –3dB, –6dB (525(U)/525(J)-line modes)
+4dB
, 0dB, –3dB, –6dB, EBUL (625-line mode)
Sub-item
1 CH1/CH3
2 CH2/CH4
OUTPUT LEVEL Set the reference level for audio output signals.
+4dB
, 0dB, –3dB, –6dB (525(U)/525(J)-line modes)
+4dB
, 0dB, –3dB, –6dB, EBUL (625-line mode)
NETWORK CONFIG: items relating to network settings
Item Setting
DHCP Set whether to assign an IP address automatically with the DHCP server.
DISABLE
: Do not assign automatically.
ENABLE: Assign automatically.
IP ADDRESS PRESET Set IP address.
192.168.001.010
Note
When DHCP is set to “ENABLE,” it is not possible to set the IP address.
SUBNET MASK PRESET Set the subnet mask.
255.255.255.000
Note
When DHCP is set to “ENABLE,” it is not possible to set the subnet mask.
DEFAULT GATEWAY PRESET Set the default gateway.
000.000.000.000
Note
When DHCP is set to “ENABLE,” it is not possible to set the default gateway.
16×8