Filter
Top Products
Chapter 9 Maintenance and Troubleshooting
122
9-3 Alarms
a) With respect to setting of basic menu item 016
Alarms relating to audio and video signals
a) With respect to setting of basic menu item 016
A mode err! limit An editing operation was attempted on a
recorded disc, when one of the following
audio settings differed from the settings
of this unit.
• Number of quantizing bits and
recording channels
• Handling of digital audio signals (audio
or non-audio)
To edit this disc, change the following
settings.
• Maintenance menu item “AUDIO
CONFIG” - “DATA LENGTH”
• Maintenance menu item “AUDIO
CONFIG” - “NON-AUDIO INPUT”
See 8-4-2 “Maintenance Menu Operations”
(page 108) about how to make these
settings.
NON-AUDIO! limit An edit preset was attempted on one
channel in an audio channel pair (CH1/2,
CH3/4, CH5/6, CH7/8) when digital
audio signals were set to non-audio.
Insert editing with non-audio signals must
be done on a channel pair. To do insert
editing with audio signals on a single
channel, set maintenance menu item
“AUDIO CONFIG” - “NON-AUDIO INPUT”
to “audio.”
See 8-4-2 “Maintenance Menu Operations”
(page 108) about how to make this setting.
ILL. REF! off The playback system and recording
system are not synchronized.
Input a reference video signal to the player
and recorder.
ILL. REC! limit A sync error between encoder and input
signal occurred during recording.
Contact your Sony service representative.
ILL. PLAY! limit An audio/video phase error occurred
during playback.
MEM. Full! limit A memory write error occurred.
MEM. Empty limit Playback data in memory was lost, and
playback stopped.
List Exists off An attempt was made to edit a clip
referenced by sub clips.
Delete all clip lists.
See 5-3-4 “Deleting Clip Lists From Disc”
(page 68).
Clip End! off An attempt was made to edit across clip
boundaries.
Editing across multiple clips is not possible.
Recording limit More time than normal is required for
recording processing, because
recording is being done while avoiding
defects on the disc.
Wait until recording finishes.
Message in time
data display
Display
condition
a)
Description Action
Message in time
data display
Display
condition
a)
Description Action
REF NON-STD off A signal other than a standard reference
video signal was input to the REF.VIDEO
IN connector.
Input a standard reference video signal to
the REF.VIDEO IN connector.
No INPUT! on An attempt to record was made with no
input video signal.
Input a video signal, and select it.
VIN NON-STD on Recording is being done with a signal
other than a standard video signal input
to the VIDEO IN connector.
Input a standard video signal to the VIDEO
IN connector.
EMPHASIS! on An unsupported audio emphasis signal
(“EMPHASIS ON” signal) was input.
This unit does not support “EMPHASIS
ON” audio signals. Input “EMPHASIS OFF”
signal.