Filter
Top Products
Chapter 8 Menus
107
8-4 Maintenance Menu
For details of how to make settings, see “To change
network settings” (page 109).
For details about OTHERS items other than the above,
refer to the Maintenance Manual.
LINK SPEED Set the communications speed.
AUTO, 10Mbps, 100Mbps, 1000Mbps
DUPLEX Set the communications method.
AUTO
Full Duplex: Full duplex
Half Duplex: Half duplex
NETWORK CONFIG: items relating to network settings
Item Setting
SETUP MAINTENANCE: items relating to the setup menu
Item Setting
EXTENDED MENU Select whether or not to display the extended menu.
DISABLE
: Do not display.
ENABLE: Display.
SETUP BANK4 Select the bank to be stored in menu bank 4, or reset menu bank 4.
NO OPERATION
: This function is disabled.
CURRENT: Store the current menu settings in menu bank 4.
BANK1: Store the menu bank 1 settings in menu bank 4.
BANK2: Store the menu bank 2 settings in menu bank 4.
BANK3: Store the menu bank 3 settings in menu bank 4.
RESET BANK4: Reset menu bank 4.
SAVE MENU DATA Select whether to temporarily back up (save) setup menu settings before operations such as
software upgrades.
SET button: Back up (save) the settings.
MENU button: Return to next highest menu level without backing up.
LOAD MENU DATA Select whether to restore (load) setting that were backed up (saved) with the “SAVE MENU
DATA” item.
SET button: Restore (load) the settings.
MENU button: Return to the next highest menu level without restoring.
AUTO BANK RECALL Select whether to recall settings automatically from a menu bank when the system is
powered on, and if so which menu bank to recall from.
off
: Do not recall settings from a menu bank.
from BANK1: Recall settings from menu bank 1.
from BANK2: Recall settings from menu bank 2.
from BANK3: Recall settings from menu bank 3.
from BANK4: Recall settings from menu bank 4.
RESET ALL SETUP Reset the current menu settings to the factory settings.
SET button: Reset.
MENU button: Return to the next highest menu level without resetting.
Note
The line mode setting is also cleared. If you execute this item, reset the line mode (see page
14).
OTHERS
Item Setting
SDI2 SUPER Select whether to output superimpose characters to the SDI OUT2 (SUPER) connector.
ON
: Output.
OFF: Do not output.