Filter
Top Products
31
Example: To program the TV
button
1 While pressing COMMANDER
OFF, press VOLUME – and the
desired Component Select
button.
When the Power-on command is
programmed, you will hear a beep
and “POWER ON” appears on the
display. (The display goes off when
you release the buttons.)
To clear the Power-on command
Repeat the procedure above.
The following display appears.
Adding an Extra
Function to the
Component Select
Buttons
Programming the Power-On
command of the selected
component (for Sony
components only)
When using Sony components, you can
program the Power-on signal for each
component on a Component Select
button. You can select the desired
component and power it on by just
pressing that Component Select button.
Continued