Filter
Top Products
33
Example : To program the input
select signal of your amplifier to
the CD button
1 Place the RM-AV2100 head to
head with your component’s
remote control.
2 While pressing COMMANDER
OFF, press CHANNEL + and
VOLUME +.
“LEARN” appears and all the
component names flash.
Note
The name of a Component Select button for
which a signal has already been learned
stays lit. If you want to program a new
signal for that button by learning, clear the
learned signal first (page 34).
about 2 – 4 inches
(5 – 10 cm) away
RM-AV2100
Remote control of
your component
3 Press the desired Component
Select button.
The selected component name stays
lit and “LEARN” flashes.
4 Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
(If you release the button before
you hear a beep, the signal may
not be learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and
4 again.
5 Press COMMANDER OFF.
Continued