Filter
Top Products
36
3 Press the ENTER key.
“VCR3” (the original component),
“CD” (the new component) and
“ENTER” appear twice.
4 •If the newly assigned
component is a Sony
component, press
COMMANDER OFF to finish
this procedure.
•If you need to set the
component code, follow the
steps on pages 8 and 9.
•If you need to program some
signals by the “learning”
function, follow the Steps 1 to 6
on pages 16 and 17.
Note
If “NG” flashes on the display when you press
the Component Select button at Step 1, you can
not assign another component because some of
the keys or buttons are already programmed
with the learning function (see page 32).
Try the above procedure again after clearing
the learned signals for that component.
Example: To assign a CD player
to the VCR3 button
1 While pressing COMMANDER
OFF, press CHANNEL– and
VCR3.
The number 0 - 9, “A”, “B” and
“ENTER” flash.
2 Press one of the following keys to
select a new component to assign.
In this example, press the 5 key to
select CD.
1: VCR 7: MD
2: VD 8: TV
3: SAT 9: CBL
4: AMP 0: DVD
5: CD A: TUNER
6: DECK B: DSP
Assigning Other Components to
the Component Select Buttons
(continued)