Filter
Top Products
34
Turning Off the Power
of All Components with
the Touch of a Single
Button
— System Power-Off Function (for
Sony Components only)
When the System Power-Off function is
active, you can turn off all Sony
components just by pressing the
COMMANDER OFF button for three
seconds.
Notes
•Some Sony components may not be turned
off with this function.
•The power-off signals are transmitted at
intervals that are set for the System Control
function set for the SYSTEM CONTROL 1
button (page 30). If you change the interval
for the SYSTEM CONTROL 1 button, the
interval of the System Power-Off function is
also changed.
To set the System Power-Off
function
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press CHANNEL+ and VOLUME+.
2 While pressing the RESET key, press
the Component Select button which
you want to clear.
Notes
•You can program a signal by “learning” for a
Component Select button for which a System
Control function (page 28) or the Power-On
function (page 31) has been programmed. In
this case, the System Control function or the
Power-On function is overwritten and cannot
be used. If you clear the “learned” signal
from the button, the System Control function
or the Power-On function is resumed, and
you can use it again.
•You cannot program a System Control
function (page 28) for a Component Select
button for which a signal has been
programmed by “learning.”
•You can program the Power-On function for
a Component Select button for which a signal
has been programmed by “learning,” but
then the Power-On function cannot be used.
If you clear a “learned” signal from the
button, you can use the Power-On function.
Adding an Extra Function to the
Component Select Buttons
(continued)