Filter
Top Products
39
Example: To store the On/Off
signal of an air-conditioner to
the SYSTEM CONTROL 2 button
1 Place the Commander head to
head with the remote control of
the air-conditioner.
2 While pressing COMMANDER
OFF, press CHANNEL + and
VOLUME +.
“LEARN” appears and the display
that stands for the learnable SYSTEM
CONTROL buttons flashes in the
display panel.
If a signal has been learned on that
button, the display stays lit. If you
want to program on that button, clear
the signal first (page 40).
RM-AV2100
Remote control of
your air-conditioner
about 2 – 4 inches
(5 – 10 cm) away
3 Press the SYSTEM CONTROL
button you want to teach.
“LEARN” flashes and the display for
the pressed SYSTEM CONTROL
button stays lit.
4 Press and hold down the button
of the remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
“LEARN” display stops flashing and
stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and
4 again.
5 Press COMMANDER OFF.
Continued