Filter
Top Products
20
Unit Settings
Setting the button
illumination
Button illumination is preset at the
factory to activate whenever the Remote
Commander is operated, and to switch
off automatically if you do not operate
for more than 10 seconds. You can set the
button illumination automatic-off time,
brightness, fade effect and which buttons
activate the button illumination. To
change this setting, perform the
following procedure.
1 While pressing the LIGHT button,
press the MORE button
The following “SET MODE” screen
appears.
SET MODE
>1 LIGHT OFF TIME
2 LIGHT BRIGHTNESS
2 Select “1 LIGHT OFF TIME” by
pressing the V/v button, then
press the OK button.
The following setting screen for
light-off time appears.
LIGHT OFF TIME
(-) 10sec (+)
3 Press the B/b button or the left/
right MULTI-FUNCTION button
to change the light-off time of the
button illumination.
You can set the light-off time of the
button illumination from 1 to 60
seconds. Each time the button is
pressed, the time decreases/increases
by 1 second. For example, “20sec” on
the screen means 20 seconds.
Note
When you set the automatic-off time longer
than 10 seconds (factory setting), battery
life may be shorter.
4 Press the OK button or the center
MULTI-FUNCTION button.
The following “SET MODE” screen
appears.
SET MODE
>1 LIGHT OFF TIME
2 LIGHT BRIGHTNESS
5 Select “2 LIGHT BRIGHTNESS” by
pressing the V/v button, then
press the OK button.
The following setting screen for
brightness appears.
LIGHT BRIGHTNESS
(-) LEVEL15 (+)
6 Press the B/b button or the left/
right MULTI-FUNCTION button
to change the
brightness of the button
illumination.
You can set the brightness of the
button illumination from 1 to 15.
Each time the button is pressed, the
level lighter/darker by 1.
7 Press the OK button or the center
MULTI-FUNCTION button.
The following “SET MODE” screen
appears.
SET MODE
>2 LIGHT BRIGHTNESS
3 LIGHT ON MODE