Filter
Top Products
26
Troubleshooting (continued)
Problem
A System Control function does
not work correctly.
Even if I operate an XPRESS
function, the TV does not turn
on, or it turns off.
Even if I operate an XPRESS
function, the source component
does not turn on, or it turns off.
Even if I operate an XPRESS
function, the input selector of
the TV or RCVR (Receiver/
Amplifier) does not achieve the
correct status.
The Remote Commander does
not synchronize with the
current status of components
even though I perform the
SYNC-UP operation.
Solution
• Make sure that you have programmed the commands in the
correct order.
• Try changing the orientation of the Remote Commander. If that
does not help, try placing the components as close to each other
as possible.
• Check the status of the components and make sure that you
have set the components properly to receive commands.
• The component codes are changed or new signals have been
learned for a button that has been programmed with a series of
commands. In this case, the new signals are transmitted when
the series of commands is executed.
• The Remote Commander memorizes the status of the
component’s input select and power on/off. However, if you
turn on/off the component with its own remote control or
operate the component directly, it will not recognize the current
component status. In this case, press the SYNC-UP button to
synchronize with the status of the current component and the
Remote Commander.
• If the TV turns off by its own Sleep function, the Remote
Commander does not recognize its status. Turn off the TV with
the Remote Commander.
• The Remote Commander memorizes the status of the
component’s input select and power on/off. However, if you
turn on/off the component with its own remote control or
operate the component directly, it will not recognize the current
component status. In this case, press SYNC-UP button to
synchronize the status of the current component and the Remote
Commander.
• If the TV turns off by its own Sleep function, the Remote
Commander does not recognize its status. Turn off the TV with
the Remote Commander.
• The Remote Commander memorizes the status of the
component’s input select and power on/off. However, if you
turn on/off the component with its own remote control or
operate the component directly, it will not recognize the current
component status. In this case, press the SYNC-UP button to
synchronize the status of the current component and the Remote
Commander.
• If the TV turns off by its own Sleep function, the Remote
Commander does not recognize its status. Turn off the TV with
the Remote Commander.
• Aim the Remote Commander at the components until Start
macro or Exit macro operations are finished.
• Start macro is not executed properly if the interval (delay time)
between the component’s power-on signal and input switch
signal is short. Set the interval (delay time) longer.
• Start macro is not executed properly if the interval (delay time)
between component’s input select signal is short. Set the interval
(delay time) longer.