Toshiba Flat Panel Television Flat Panel Television User Manual


 
Programming the remote control for use with
your audio/video devices
Device code setup
1. Refer to tile Device code table on pages 24-25 to find the code
for the brand of your device.
tf more than one number islisted, try each one separately until
you find the one that works.
2. Press MODE until the Mode indicator of the device (CABLE/
SAT, VCR, DVD, AUDIO1, AUD102) lights up.
3. While holding down the RECALL button, press the Channel
Number buttons to enter the four-digit code of your brand of
device. If a valid code is entered, the mode indicator will blink
twice, lfan invalid code is entered, the mode indicator will blink
one long blink.
4. Point the remote control at the device and press POWER to test
the code.
tf the device turns on, you have entered the correct code.
tf the device does not respond to the remote control, you may
have entered the wrong code. Repeat steps 3 and 4 using another
code.
5. Press MODE to select the TV mode to control the TV.
Note:
Everytime you replacethebatteries,you
mustreprogram the remote con_oL
Somenewer VCRsarecapable ofworking
on either of tworemote codesTheseVCRs
havea switch labeled "VCRI/VCR2."
ffyour VCRhas thiskind ofswitchand
doesnot respond toanyof thecodesfor
your VCRbrand,set the switchto the other
position (VCRI or VCR2)and reprogram
the remote con_ol
Searching and sampling the code of a device [8500}
If you do not know the device code for a particular target unit, you
can cycle the remote control through the available codes for that
device mode and sample the functions to find the code that properly
operates the target device. The keys available to be sampled, provided
they are applicable to that mode, are POWER, 1, VOL A, CH A, and
PLAY. Invalid keys will be ignored while in program mode.
To cycle through each available device code and sample its functions:
1. Press MODE to select the mode you want to set up.
2. While holding down the RECALL button, press 8 -5 -0 -0.
The remote control will enter program mode.
3. Point the remote control at the target device and press POWER
(or other function buttons that are available to be sampled).
4. tfthe device responds to the remote control:
Press RECALL to store the device code.
The mode indicator will blink twice and the remote control
will exit the program mode.
tf the device does not respond to the remote control:
Press A, and then press POWER.
Repeat this step until the device responds to the remote
control, and then press RECALL.
Note: Whenasearchcycleis completed, the modeindicator will blink
three times 7heremote control willbegin to cyclethrough the
availablecodesagain ff no keyispressedwithin tOsecondswhile
programming, theremote control willexittheprogram mode and
return to theprevious code
22