Filter
Top Products
Adding channels to the TV's memory
When you press Channel • or •, your TV will stop only on tile
channels you program into the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them into its memory. After the channels are programmed
automatically, you can manually add or erase individual channels (see
page 31).
To program channels automatically:
1. Press MENU, and then press • or • until the SET UP menu
appears.
2. Press • or • until TV/CABLE is highlighted.
3. Press • or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
Note:
Totune the TVtoa channelnotprogrammed
if?the channelmemory,you must usethe
ChannelNumber buttons onthe remote
control
Channel
Number
MENU
LANGUAGE ENGLESH
ANT Z2 AN_
CH PROGRAM
ADO/ERASE AOO
OU[CK CONNECT GUIDE
Channel &V
4. Press • to select CH PROGRAM.
LANGUAGE ENGLISH
ANTI/2 ANTI
OUECK CONNECT GUEDE
i{
............................................................... i_
5. Press • or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please Wait" appears.
6. _,,Vhenchannel programming is complete, the message
"Completed" appears.
7. Press Channel • or • to view the programmed channels.
3O