Filter
Top Products
33
FUNCTIONS
8.
When download is completed, the receiver will
reboot automatically. You can now exit
HyperTerminal.
9.
After the receiver is booted up, you will see a
message window informing you that the receiver’s
database is empty. Note that the password will
also be reset to the default “0000”. Now press the
“MENU” button and select your region of
residence.
10.
On the Main Menu, select “PROFILE” and then
“INFORMATION” to confirm the current software is
indeed changed to the new one. You can then
proceed to tune your receiver by following
“INSTALLATION” instructions on page 29.
Over time, Automatic Software Upgrade service will be available as broadcasters transmit new software of your
receiver. It is recommended to carry out the software upgrade so that the receiver is equipped to perform better.
1.
When a new version of software for Toshiba HD-
C26H is found, an OSD appears prompting for a
software upgrade.
2.
Press the “ENTER” button to accept the software
upgrade or the “EXIT” button to cancel.
3.
If the software upgrade has been accepted, the
system will be rebooted. Upon startup,
downloading of the new software will take place.
Progress is shown on the front panel display with
an “OTA” and a running line.
4.
The downloading process usually takes a short
while and when it has completed, the system will
reboot again. Upon the second startup, the system
has completed the upgrading process and the
database will be empty as default. Then proceed
with the Installation process. (Refer to page 29)