Filter
Top Products
41
FUNCTIONS
FP DISPLAY SETUP
1.
Highlight “FP DISPLAY SETUP” and press the
“ENTER” button.
2.
Use the “▲” and “▼” buttons to choose between
“MODE” and “DISP BRIGHTNESS”.
3.
Under “MODE”, use the “◄” and “►” buttons to
choose between “TIME” and “CHANNEL
NUMBER”. This will change the Front Panel
display information.
4.
Under “DISP ON STANDBY”, use the “◄” and “►”
buttons to choose between “OFF” and “ON”. This
will change the Front Panel display mode in
standby mode. In “ON” state, the Front Panel will
show the current time in 24HR format during
standby mode. While in the “OFF” state, the seven
segmented LED will be off during standby.
Notes:
1. TIME mode sets the receiver’s front panel Time
and Channel Display to show current time. The
displayed current time is purely based on the
time sent by the broadcaster of the channel you
are currently viewing, which may not be accurate.
2. When the receiver is in off-air mode, CHANNEL
NUMBER sets the receiver’s front panel Time
and Channel Display to show the channel
number sent by the broadcaster.
INFORMATION
1.
Highlight “INFORMATION” and press the
“ENTER” button to check hardware and software
versions.