Filter
Top Products
46
A.RATIO (ASPECT RATIO)
1.
Press the “A.RATIO” button on the remote control to show current aspect ratio.
2.
Within 5 seconds, pressing the “A.RATIO” button again will change the aspect ratio
. Keep pressing this button
will adjust the aspect ratio among “Normal”, “Letterbox” and “Widescreen”.
3.
The recommended settings are shown in the table below:
If you are watching a 4:3 program If you are watching a 16:9 program
If you are using a 4:3 TV
Use “4:3
NORMAL”. If this setting is selected and your
program is in 16:9, both sides of the picture will be cut
off to fill your 4:3 TV.
Use “4:3 LETTERBOX”. This setting
allows you to
display a 16:9 program on a 4:3 TV screen in letterbox
(with masking bars above and below the picture). If
this viewing is continued for a long period of time, it
may cause a permanent image burn to the TV screen.
If you are using a 16:9 TV
Use “16:9 WIDESCREEN
”. This setting allows you to
display a 4:3 program on a 16:9 TV screen in
widescreen (with masking bars on both sides of the
picture).
If this viewing is continued for a long period of
time, it may cause a permane
nt image burn to the TV
screen.
Use “16:9
WIDESCREEN”. This is the default aspect
ratio setting for Australia.
Note: If, for purposes other than personal viewing, you display a program in an aspect ratio different from its
original setting, you may infringe on the copyrights that the program may be under.
SLEEP
The “SLEEP” button on the remote control is used to set the off-timer value.
To set the off-timer:
1.
Press “SLEEP” button to start the timer at “OFF”.
2.
Next press of the “SLEEP” button (within 5 seconds) will set the receiver to the next off-timer value. Use the
“SLEEP” button to set the desired off-timer value.
3.
The menu turns off after 5 seconds, and the timer starts.
OFF 30 min 60 min 90 min 120 min