Filter
Top Products
60
6 INSTRUCTION GUIDE FOR PROGRAMMING REMOTE CONTROL
The remote control can be compatible with various brands of TV by setting their control codes. The TOSHIBA
code has initially been set to control TOSHIBA TVs. Refer to the four methods below for programming your
remote control and use the one that best suits your setup. (Note: Every change of batteries in the remote control
unit will result in a reset to the default Toshiba code of 138)
Due to the great variety of TV systems, some makes and models are not compatible with your receiver’s remote
control. If you reach the end of the available codes without finding a code that works with your device, you will
need to use your TV system’s remote control to turn it on and off, and control the volume. Even if the code is
found, there is a possibility that not all the buttons on your receiver’s remote control will work with your TV.
Control codes for regions Europe, USA and China are available on pages 61 to 68.
1. Programming
(a) Refer to the code list for the 3-digit code of the TV brand.
(b) Press the “TV FUNCTION” button
to set the remote control operating your TV.
(c) Press and hold the “PROG.” button, then enter the three digits of your TV brand code using the
“CHANNEL NUMBER” buttons.
(d) Check response on LED with every digit pressed;
1) LED lights up after the first digit press
2) LED blinks once after the second digit press
3) If the code is available, LED goes off after the third digit press or else the LED will blink twice and
goes off, indicating unavailable code. Go back to step (c) if an unavailable code was entered.
(e) Release “PROG.” button to leave the programming mode.
(f) Point the remote control at your TV and use each button listed below to make sure your TV is
operated correctly. (Refer to page 13 and 14 for location of buttons on remote control unit)
- STANDBY/ON , INPUT SELECT, MUTE, CHANNEL UP/DOWN, VOLUME UP/DOWN, CHANNEL
NUMBER and DIGIT SELECTION buttons.
2. Auto code search (Region)
If none of the codes listed allows you to control your TV, a code search may detect the correct code. This
function performs a forward search in the code list by region.
(a) Turn on your TV. Press and hold the “PROG.” button, then press the “TV FUNCTION” button.
(b) LED lights up, indicating that the remote control is now in programming mode. (LED will go off and
remote control exits programming mode if the “TV” button is pressed or no further activity is sensed
after ten seconds)
(c) Release the “PROG.” and “TV FUNCTION” buttons.
(d) Input the code “994” (for Europe models) or “995” (for US models) or “996” (for China models).
(e) The remote control is now in “Auto code search” mode.
APPENDIX