Filter
Top Products
131
Recording
Playback
Others
Introduction
Editing
Function setup
Program
Timer programming cannot be completed.
• Clock setting has not been completed.
→Complete the clock setting (
page 28,
“INSTALLATION GUIDE”).
• The programs list is full.
→Cancel unwanted programs (
page 32).
Remote control
The remote control does not work.
• The batteries in the remote control are exhausted.
→Replace all the batteries in the remote control
(
page 12, “INSTALLATION GUIDE”).
• The light emitter of the remote control is not pointed
at the receptor of this recorder.
→Point the emitter of the remote control at the
receptor of this recorder.
• The receptor of this recorder is located too far away
from the remote control.
→Operate the remote control within 7 meters (23 ft)
from the receptor of this recorder.
• There are obstacles between the remote control and
this recorder.
→Remove any obstacles.
• The receptor is disturbed by sunlight or fluorescent
light.
→Change the place of this recorder or shield the
light.
• The remote control mode is not appropriate.
→Adjust the remote control mode of the remote
control and this recorder (
page 40,
“INSTALLATION GUIDE”).
Clock
The clock blinks.
→Complete the initial setting again ( page 24,
“INSTALLATION GUIDE”).
The clock does not keep time.
→Set the time and date manually ( page 28,
“INSTALLATION GUIDE”).
Recording
Cannot be recorded on a DVD-RAM disc.
• The disc is protected from deleting data.
→Set the write-protect tab to the opposite of
“PROTECT” (
page 7).
• The disc is protected by a PC or the recorder.
→Disable the protection on the device which
protected the disc.
• The disc space is not sufficient.
→Delete unwanted data (
page 42) or prepare a
new disc.
• The disc is not initialized.
→Initialize the disc (
page 26).
• The disc may contain errors.
→Complete the physical format on the disc
(
page 27).
• The physical format on the disc is not completed.
→Complete the physical format on the disc
(
page 27).
• The disc has been recorded in the NTSC system.
You can replay a title that has been recorded in the
NTSC system, but you cannot display it in the
thumbnail or use the edit or dubbing functions.
→You can use the recorder to initialize the disc to
use it with this recorder, but the contents will be
lost. If you do not want to initialize the disc, you
can still play it, but no other functions are available.
Cannot be recorded on the HDD.
• The DVD mode is selected.
→Press the HDD button.
• The disc space of the HDD is not sufficient.
→Delete unwanted data (
page 42) or move the
contents to DVD-RAM discs (
page 87).
• Some causes such as power failure may set the
recorder to reject the operation to protect the HDD.
→Copy necessary contents recorded in the HDD to
a DVD-RAM disc, and initialize the HDD.
RD-XS24SB_Ope_E_p127-137 9/1/05, 12:00 AM131