Filter
Top Products
20
Is your recorder ready?
• Refer to the supplied “INSTALLATION GUIDE”
manual and finish the necessary preparations.
•Turn on the connected equipment such as a TV or
audio system and select the input from the recorder.
Turning the power on
(This owner’s manual instructions are based on
the assumption that all proper connections have
been completed and the TV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
When the power turns on, the display of the front panel
shows “ON”.
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.
The display of the front panel changes to the counter.
If a disc is not loaded, it shows the current channel.
Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the
CHANNEL or the number buttons.
Loading a disc
Check disc compatibility beforehand ( page 6) and
use a proper playable disc.
Caution
• Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury. Keep a close watch on
children.
• Do not use a cracked, deformed, or repaired disc.
1 Open the disc tray.
Press
on the front panel or the OPEN/CLOSE
button on the remote control.
2 Insert a disc.
Disc without a cartridge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
Place a disc in the
inside hollow.
Introduction
Before operating this recorder
ON/STANDBY button
TV
DVD
INPUT SELECT
CHANNEL
HDD DVD
TOP MENU
MENU
MENU
TIMESLIP
CHANNELVOLUME
INPUT SELECT
OPEN/CLOSE
ON/STANDBY button
CHANNEL buttons
TV
DVD
INPUT SELECT
CHANNEL
HDD DVD
TOP MENU
MENU
MENU
TIMESLIP
CHANNELVOLUME
INPUT SELECT
OPEN/CLOSE
button
OPEN/CLOSE button
Loading
e.g.
RD-XS24SB_Ope_E_p020-024 8/31/05, 11:52 PM20