Filter
Top Products
11
WARNING
INDICATOR
IGN
46 CM 60CM
WINEGARD
P/N:2750225
120 VAC 60 Hz
100 WATTS MAX
TO
RECEIVER
TO
ANTENNA
REMOTE
CONTROL
PANEL
1 GREEN/BLACK
2 RED/BLACK
3 RED/WHITE
4 GREEN
5 RED
6 BLACK
7 ORANGE
8 BLUE
9 WHITE
10 BLACK/WHITE
11 ORANGE/BLACK
12 WHITE/BLACK
13 BLUE/BLACK
After all other
connections are made
connect AC power
cord to 120 VAC outlet
.
Figure 12
Optional RD-9901 Remote
Control Wall Plate. Connected
by 25' telephone-type wire with
modular plug-in connections.
GOLD
SILVER
Connect to vehicle ground.
Connect to ignition +12 VDC.
Connect 13 pin connector
here, makeing sure wire
colors match. Secure
connector to positioner
with screws molded into
connector.
Connect 75 ohm coaxial
cable from antenna.
Connect 75 ohm coaxial
cable to SATELLITE IN
jack on receiver.
This connection is optional. If used
antenna will be put into travel position
whenever the ignition is turned ON and
there is AC power to the positioner.
Optional RD-9911 Warning
Device Refer to Figure 15,
Page 14 for operation and
installation.
Rev. 6/98
Make sure switch is in
the 46CM position.
Switch removed 2/23/98.