Filter
Top Products
36
Az(X) = XXXXX
El (X) = XXXXX XXX
Signal Level - This will vary
according to received signal
Azimuth Count - Numbers changed
according to antenna position
Azimuth Count - Numbers changed
according to antenna position
Azimuth Stop Condition
(see note)
Elevation Stop Condition
(see note)
Figure 28
NOTE: There are five (5) motor stop conditions:
0 - Motor stopped under normal conditions.
1 - Motor stopped because a limit switch was encountered.
2 - Motor stopped because motor count limit was reached.
3 - Motor stopped because s button was pressed on the positioner.
4 - Motor stopped because of elevation/rotation constraints (antenna
was physically stopped by an obstruction or other obstacle).
Under normal conditions the stop conditions will be 0, 1, 2, or 3. If you get
number 4, refer to Troubleshooting section.