Filter
Top Products
15
RD-9911 Warning Device Installation/Operation
To install the Warning Device, proceed as follows:
1. Connect the gold colored wire of the warning device wire harness to ignition
+12 VDC (there is only +12 VDC present when ignition is turned ON) See
Figure 17.
2. Connect the silver colored wire to vehicle ground. See Figure 17.
3. Connect other end of wire (end with molded plug) to warning device. See
Figure 17.
4. Insert the two "AA" batteries into the warning device.
5. Connect the single RCA cable to the WARNING INDICATOR jack on
positioner (see Figure 11). Connect the other end to the warning device. See
Figure 17.
NOTE: It is recommended that you place the warning device where it will
be visible when you start your vehicle. There is no buzzer, only lights in
the device. Velcro is provided to help in the placement of the device.
Operation: A red light indicates that the system is still in the raised
position and not ready for travel. Red light goes off when in down
position. A yellow light comes on when battery is low. Lights only come
on when +12 VDC is applied to warning device.
Connect to ignition +12 VDC
Positioner Rear Panel
Connect to vehicle ground
Warning Device
Install two "AA"
batteries provided
GOLD
SILVER
Figure 17
RCA cable
WARNING
INDICATOR
Rev. 6/98