Filter
Top Products
40
5. After entering satellite name, you must enter satellite location. This is
usually expressed in so many degrees west (ex. the DSS satellites are located
at 101
o
west). Your receiver manual or program provider should tell you the
satellite position. To enter satellite position, press [RIGHT] arrow key until
satellite name is no longer highlighted, see Figure 37. Press [UP/DOWN] arrow
keys to scroll to correct number. Numbers will scroll in .5
o
increments. If satellite
location is XX.3, scroll number to XX.5. If number is XX.2, scroll number to XX.0.
Valid satellite locations are 60 to 165 degrees.
6. Press [SELECT A] to enter new satellite into positioner memory. See
Figure 37. If you do not want to enter satellite into the memory press [Quit] to
return to previous menu.
Model RD-9900
PINNACLE
POSITIONER
by WINEGARD
SELECT B
SELECT A
8. Press SELECT A to enter
new satellite as search
satellite
Winegard* 165.0
Edit
Figure 38
*NOTE: Winegard 165.0 is not a satellite, and is used only as an example.
7. Press [SELECT A] again to enter your new satellite as the search satellite.
See figure 38.
Model RD-9900
PINNACLE
POSITIONER
by WINEGARD
SELECT B
SELECT A
Figure 37
Winegard* 165.0
Quit
7. Press SELECT A to enter
satellite into memory
6. Press UP/DOWN arrow keys to
enter satellite position
5. Press RIGHT arrow key untill
satellite name is no longer
highlighted