24
Model RD-9900
PINNACLE
POSITIONER
by WINEGARD
SELECT B
SELECT A
Model RD-9900
PINNACLE
POSITIONER
by WINEGARD
SELECT B
SELECT A
SYSTEM OPERATION (FINDING THE SATELLITE(S)
Figure 1
Figure 2
4. Press [SELECT A] to enter the search function, Figure 1. (Press [SELECT
B] if Search DSS is bottom option on screen.
5. Press [SELECT A] Select a City, Figure 2. There is a list of 125 cities in
the continental Untied States stored in the positioner memory. See Programmed
City Locations, page 28.
Search DSS
Park
Select a City
Enter Elevation
2. Press SELECT A
3. Press SELECT A
1. Press UP/DOWN arrow buttons to get Search DSS on screen
Your new Winegard RV Digital Satellite System is an easy-to-install, easy-to-
use satellite TV reception system. Because it mounts on the top of your
recreational vehicle, it goes where you go and provides quality reception of
digital satellite signal in the continental United States only.
NOTE: All commands will be shown in bold with brackets, example
[SELECT A].
One requirement must be met to fully enjoy automatic system TV viewing.
The RV must be reasonably level. Any of the leveling indicators available
should be adequate for this purpose. If the RV is not leveled, the system
may not find the high power satellites.
After the RV has been leveled, proceed as follows:
There are three ways to find the satellite(s). Using the city menu to find the
closest city, entering the elevation angle for your location or entering the
latitude and longitude for your location. Each is explained in the following
paragraphs.
1. Turn TV ON and tune to channel 3 or 4 (output channel of receiver).
2. Press [POWER] on receiver remote to turn satellite receiver on.
3. On positioner press [UP/DOWN] arrow button until Search DSS appears
on the positioner screen, Figure 1. If you want to search for a different satellite
refer to Edit Menu on page 18 to change search satellites.
Finding the Satellite
Method 1:
Using the City Menu
NOTE: SELECT A chooses
top option, SELECT B
chooses bottom option.
Rev. 6/97