Woods Equipment BH7500 TV Mount User Manual


 
18 Hydraulic Installation
MAN0157 (10/12/01)
Connect Fittings to Hydraulic Manifold
IMPORTANT
Incorrect installation can damage the tractor
hydraulic system. Read and understand instructions
in the tractor manual before connecting.
NOTE: This hose kit contains items that will not be used
for installation with the 1012/1016 loader.
1. Locate the hydraulic manifold on the tractor chassis
right side under the platform. The manifold contains
three auxiliary hydraulic ports and the control screw as
shown in Figure 26.
The control screw (4) is used to direct hydraulic flow and
must be positioned correctly to prevent damage to the
tractor hydraulic system.
2. Using a screwdriver, carefully turn control screw
counter-clockwise 1/4 turn to the vertical position.
See the tractor operator’s manual for control screw
instructions.
3. Use thread sealant on all pipe thread connections
and tighten securely to prevent leaks.
4. Remove three port plugs (1 - POWER BEYOND), (2
- PRESSURE), and (3 - RETURN) from manifold ports.
IMPORTANT
If loader valve is removed, the control screw
must be turned back to the three o’clock position to
prevent damage to tractor hydraulic system.
Figure 26 Tractor Hydraulic Manifold
3
#1003179 Hose Kit
(For BH6500/7500 Backhoe & 1012/1016 Loaders)
1
4
2
3
DP10
Control Screw (Backhoe or Loader Valve Not Installed)
1 - Power-Beyond Port
2 - Pressure Port
3 - Tank/Return
4 - Control Screw
Control Screw (Backhoe or Loader Valve Installed)