Filter
Top Products
Hydraulic Installation 19
MAN0157 (10/12/01)
#1003179 Hose Kit for 1012/1016 Loader Cont’d
Connect Fittings to hydraulic Manifold
(Cont’d)
NOTE: Refer to manual MAN0104 Loader Mounting Kit
#111767 for installation of loader valve kit #46675
NOTE: Loader valve hose kit #1002657 will be required
to complete this installation. If hose kit is already
installed, many of the fittings will need to be removed.
1. Remove banjo screw fitting on hydraulic line above
the return port (not shown). This will allow clearance to
install RETURN port fittings.
2. Install fittings, quick couplers, dust cap, and colored
bands to the hydraulic manifold RETURN port as shown
in Figure 27.
3. Install banjo screw previously removed.
Figure 27 Return Port Fittings Installation
4. Install fittings, quick couplers, dust cap, and colored
bands to the hydraulic manifold POWER BEYOND
(PBY) port as shown in Figure 28.
A. 66369 Adapter, 3/8 BSTPM x 3/8 NPTF
B. 315030 Adapter, 3/8 NPTM x 3/8 NPTM
D. 66367 Elbow, 3/8NPTM x 3/8 NPTM
G. 66368 Tee run, 3/8
J. 64300 Male quick coupler, 3/8
K. 395065 Dust cap, 3/8
M. 56062 Plastic band, Yellow
22. 315037 Adapter, 3/8 NPTM x 3/4 JICM
24. 316029 Elbow, 3/8 BSPTM x 3/8 NPTF
Figure 28 Power Beyond Fitting Installation
5. Install elbow (24) and adapter (22) to the hydraulic
manifold PRESSURE port as shown in Figure 29.
Figure 29 Pressure Fitting Installation
3
A
G
2
2
B
K
N
J
RET
U
RN P
O
R
T
CD5918-10
J
M
K
D
A
PBY P
O
R
T
CD5918-11
2
2
2
4
PRE
SSU
RE P
O
R
T
CD5918-12