Filter
Top Products
Installation 5
MAN0157 (10/12/01)
SUB-FRAME INSTALLATION Cont’d
If you do not understand any part of this man-
ual and need assistance, see your dealer.
Always wear relatively tight and belted cloth-
ing to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and
head.
* Operator’s seat must be located in the lowest and
most forward position to obtain 40” minimum radius.
Figure 1 Sub-Frame Clearance
TRACTOR PREPARATION
1. Refer to the WOODS BH6500/7500 Backhoe
Operator’s Manual for backhoe assembly instruc-
tions.
NOTE: For installing this sub-frame, reference to
right, left, forward and rearward directions are deter-
mined from the operator’s position in the tractor seat.
2. Remove the tractor top link, 3-point lift lower
arms, and anti-sway links.
NOTE: The pins and hardware that attach the lower
links to the transmission will be needed for the sub-
frame installation.
NOTE: Loader mounting kit #111768 or Kioti 1470
loader mount must be installed prior to sub-frame
mounting kit #1004327 installation.
NOTE: Leave all hardware loose until sub-frame
weldment has been fit up.
Modify PTO Shield.
1. Remove PTO shield from tractor.
2. Cut out right and left corner of PTO shield as
shown in Figure 2.
3. Reinstall PTO shield on tractor.
NOTE: Make sure 3-point lower lift pins can be
removed without interfering with PTO shield installed.
Remove more material as needed.
■ Make sure shields and guards are properly
installed and in good condition. Replace if dam-
aged
Figure 2 Modified PTO Shield.
CAUTION
DP7
1.25”
2.50”