Filter
Top Products
Installation 7
MAN0157 (10/12/01)
SUB-FRAME INSTALLATION Cont’d
Install Rear Hanger Bracket
1. Install rear hanger bracket (6) to bottom of transmis-
sion housing. Position bracket with the slots to the rear
of the tractor. Secure using two cap screws (12) and
hardened flat washers (13).
2. Torque these cap screws to 87 lbs.-ft. at this time.
Figure 6 Rear Hanger Bracket Installed
2. 1004329 Rear mount
6. 62977 Rear hanger bracket
12. 16087 M14 x 1.5P x 35mm Cap screw
13. 46070 9/16 Hardened flat washer, thick
Figure 7 Rear Hanger & Rear Mount
Install Rear Mount
1. Slide round bar of rear mount (2) into slots of rear
hanger bracket (Figure 6 & Figure 7).
2. Pivot rear mount upward and secure to tractor with
3-point lower link pins and hardware (Figure 8).
IMPORTANT
■ Figure 8 is shown with PTO shield removed for
clarification. Only remove PTO shield for modifica-
tions described on 5.
Figure 8 Rear Mount Installed
12
13
6
DP1
2
CD5915-1
REAR
6
13
12
3-Point Lower
Link Pin
2
DP2