Filter
Top Products
PV154 - 923-03506 1-5 ZP26/28 - REMOTES
REMOTE CONTROL
REMOTE BUTTON DESCRIPTIONS
PROGRAMMING THE REMOTE
If you’re using Zenith products, the remote is already
programmed for most common codes. For other brands,
or if your remote fails to control your Zenith products,
you’ll have to program the remote.
Make sure the batteries are installed and follow these
steps for each product:
1. Turn on the device to be operated.
2. Press and hold the device button until the indicator
light turns on, continue holding down the device
button.
3. Now the remote control is ready to program the code
for the corresponding component. Enter the product’s
code number using the number buttons. Code num-
bers can be found on the following pages. The indi-
cator light will flash three times and turn off if the
code was accepted.
123
456
789
0
mute
vol
ch
flshbk
pause rew
ff
play
record stop
skip
CC
quit
split
tv
vcr
power
dvd
hd/stb
cable
menu
multi
tv
vcr
cable
hd/stb
light
dvd
sleep
mo de
aspect
c skip
pip ch
display
fav ch
theatr
source
Part Number
MBR6045A
924-10098
LIGHT
Lights keys for five seconds.
POWER
TurnsTV On and Off.
ASPECT
Selects different picture
proportion formats.
DISPLAY
Shows current on-screen settings.
FLSHBK (FLASHBACK)
Returns to the previously
tuned channel.
MULTI
Turns “POP-3” feature on and off.
PIP CH
Channel tuning switch in Split
Screen mode. See Split Screen
section.
C SKIP
Channel Skip. Tunes to last channel
viewed. Tunes back to original
channel after 30, 60, 90, 120,
150, or 180 seconds.
FAVORITE CHANNEL
Select among 6 different channel
classifications.
QUIT
Leaves programming menus and
clears screen of displays
THUMBSTICK
(Menu Operation Directional
Arrows and Select key)
Up/Down arrows choose, and
Left/Right arrows adjust menu
options. Press the bulls eye Select
button in the center of the directional
arrows to confirm selection.
THEATER
Direct access to theater modes.
CH - CHANNEL (+/ -)
Tunes to next higher/lower
available channel.
MODE INDICATOR LIGHTS
Light indicates mode when
keys are pressed.
SOURCE
Selects available TV sources.
MUTE
Press once for Soft Mute,
press again for full Mute.
SPLIT
Turns the “SplitScreen”
feature on and off.
SLEEP (TIMER)
Sets a preset time
for the TV to turn off.
CC
Turns On/Off Closed
caption/text options.
MENU
Displays on-screen menus.
MODES
TV, VCR, Cable, DVD, HD/STB
Switches remote operating mode
to control other devices. After pressing
a Mode switch key, wait2-3seconds
before pressing any other key.
NUMBER KEYPAD0-9
Selects channels directly and
enters numerical values.
Use as the dash when selecting
digital channel numbers.
VOL - (VOLUME) (+/-)
+ Increases the sound level.
- Decreases the sound level.
Record, Stop, Pause, REW (Rewind),
Play, FF (Fast Forward).These buttons
still operate the VCR while remote is
in TV operating mode.
DIGITAL MODE DASH
VCR FUNCTION KEYS
4. Release the mode key. Point the remote at the de-
vice and press the POWER key. The device should
turn off. If not, try the other 3-number codes listed.
NOTE: Use the CABLE device button for satellite receivers.
Use the DVD device button for home audio
components.