A SERVICE OF

logo

Open as PDF
next previous
ACRO 26
2.2 Normal Display, cont.
DN
SELECT
CH CH CLEARUP
Press simultaneously
to access the List
Mode/System Set-Up Mode
Press Select and
either the + or - keys
simultaneously to
adjust the contrast of
the LCD display
Press the Clear key
to reset to factory
settings
Press the UP and DN keys
simultaneously to change
to Function Mode (with
power switch ON)
When timer function is
active, use CH key to
start/stop timer
Press the UP and DN keys
simultaneously and switch the
power from OFF to ON to
change the system to the
System Set-Up Mode
To set the System Set-Up Mode, press the UP and DN keys
simultaneously and turn the power switch from OFF to ON.
Functions are selectable by pressing either the DN or UP keys.
Individual settings are explained later at each function. In this
mode, servos are not activated, but operating signals are
transmitting (only when the Tx module is in place). However, use
extra caution not to interfere with other frequencies. By pressing
the DN and UP keys simultaneously, you can return to the normal
display, which allows the servos to again operate.
3.1 System Set-Up Mode
[INFO-DISP]
↕
From the Normal Display, the following inputs can be made:
When setting various functions with the buttons shown below,
start either in the Function Mode or the System Set-Up Mode.
3. System Set-Up Mode Functions
Pg. 28 Information Display
Pg. 29 Model Select and Copy
Pg. 29 Model Name Input
Pg. 30 Model Type Selection Function
Pg. 30 Data Reset
Pg. 31 Modulation Selection
Pg. 32 Data Transfer between traqnsmitters
Pg. 34 Wing Type Selection
Pg. 35 Spoiler Channel Input Selection
SYSTEM SET-UP MODE
Use either the UP
or DN key to scroll
through the menu
and access the
applicable function