A SERVICE OF

logo

Open as PDF
next previous
ACRO 53
B. Use of Programmable Trainer Function
In this mode, the master may assign functions to the student one
at a time to make learning to fly easier. For example, the master
may assign the slave rudder and elevator. Then, when the trainer
switch is activated (pulled toward you), the slave has control of
only rudder and elevator while the master retains control of
throttle and aileron.
The normal display screen will show the
type of trainer function selected once the
trainer function is activated
programmable trainer display
Channel display being programmed
If an arrow appears on
the Master transmitter
in this position, it
indicates the direction
the Slave channel trim
lever must be moved
on the Slave
transmitter
SLAV: Applicable channel set to Slave
MAST: Applicable channel to Master
Normal trainer display
4.15 Trainer (Function Mode), cont.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
Press to reset to
factory preset
position (All Master)
DN
SELECT
CH CH CLEARUP
To Timer Function
To Fail-Safe (PCM
Only) or programmable
mixing
Press either key
to move arrow to
desired channel
Press either the + or -
key to select channels
to be activated
(Master-Slave)
When all channels are
set for Master,
condition is set to
Normal Trainer