ST-4
USER MANUAL
20
Press and hold for 2’’ the MPEG PICT
[5] key to show the currently tuned
channel video signal (croming from the built-in demodulator) on the TFT display [G],
and to listen to the relevant audio through the meter built-in loud speaker.
9.2 NAVIGATE INTO THE CHANNEL PLAN (USER DEFINED
CHANNEL PLAN)
To create an User Defined Channel Plan, proceed as described in the Chapter 12
CREATE MEMORY PLANS at page 38.
Using the Standard Navigation Mode, highlight the item MANUAL MEMORY, then
select the required channels group (MANUxx plan).
Press once and release the MEAS
[4] key.
The LCD [F] top row will display (from left to right): the selected channel plan, the
currently tuned channel and the corresponding frequency value.
Press the encoder [M] to highlight the current channel ID and rotate it to surf the
channels within the selected memory plan. Each step of the encoder moves the
channel ID one step forward or backward. To speed up the channel ID selection,
rotate the encoder [M] continuously.
Press and hold for 2’’ the MPEG PICT
[5] key to show the currently tuned
channel video signal (croming from the built-in demodulator) on the TFT display [G],
and to listen to the relevant audio through the meter built-in loud speaker.
THE METER WILL TUNE ONLY THE CHANNELS INCLUDED IN THE SELECTED
CHANNEL PLAN. To explore/navigate into a new user defined channel plan,
press once and release the PLAN key and, using the Standard Navigation
Mode, highlight the MANUAL MEMORY item to select the required channel plan.
