A SERVICE OF

logo

ST-4
USER MANUAL
34 bis
WARNING: only the channels included into the channel plan (PLAN) currently in use
will be displayed.
Refer to Chapter 9 SIGNAL TUNING: PLAN at page 19
The meter LCD will at any time display the current frequency value (first row, top right) and
the relevant signal level measurement (bottom row, MRK
).
.
Then select the desired span value. Only pre-defined span values (from 2 MHz to FULL)
can be set. No fine adjustment is possible.
Press once and release the SPECT [3] key again to quit the MaxHold function.
Using the Standard Navigation Mode, highlight the BARS TYPE item and select the
required display mode as described below.