Filter
Top Products
Programming the Mio R-4
45
Mio Modero R-4
Page Commands (Cont.)
@PPT
Set a popup page
to timeout within a
specified time
Set a specific popup page to timeout within a specified time. Timeout is in 1/10 seconds. If
timeout is empty, popup page will clear the timeout.
Syntax:
SEND_COMMAND <DEV>,"'@PPT-<popup page name>;<timeout>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• timeout = timeout duration in 1/10ths of a second.
Example:
SEND_COMMAND Device,"'@PPT-Popup1;30'"
Sets the popup page 'Popup1' to timeout within 3 seconds.
@PPX
Close all popups
on all pages
Close all popups on all pages. This command works in the same way as the 'Clear All'
command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'@PPX'"
Example:
SEND_COMMAND Panel,"'@PPX'"
Close all popups on all pages.
@PSE
Set the show
effect for a popup
page
Set the show effect for the specified popup page to the named show effect.
Syntax:
SEND_COMMAND <DEV>,"'@PSE-<popup page name>;<show effect name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
• show effect name = Refers to the popup effect name being used.
Example:
SEND_COMMAND Device,"'@PSE-Popup1;Slide from Left'"
Sets the Popup1 show effect name to 'Slide from Left'.
@PSP
Set the show
effect position
Set the show effect position. Only 1 coordinate is ever needed for an effect, however the
command will specify both. This command sets the location at which the effect will begin
at.
Syntax:
SEND_COMMAND <DEV>,"'@PSP-<popup page name>;<x coordinate>,<y
coordinate>'"
Variable:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
Example:
SEND_COMMAND Device,"'@PSP-Popup1;100,0'"
Sets the Popup1 show effect x-coordinate value to 100 and the y-coordinate value to 0.
@PST
Set the show
effect time for a
popup page
Set the show effect time for the specified popup page.
Syntax:
SEND_COMMAND <DEV>,"'@PST-<popup page name>;<show effect time>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
• show effect time = Given in 1/10ths of a second.
Example:
SEND_COMMAND Device,"'@PST-Popup1;50'"
Sets the Popup1 show effect time to 5 seconds.