Filter
Top Products
Programming the Mio R-4
79
Mio Modero R-4
Input Commands
A device must first be defined in the NetLinx programming language with values for the Device: Port:
System (in all programming examples - Remote is used in place of these values).
Panel Setup Commands
A device must first be defined in the NetLinx programming language with values for the Device: Port:
System (in all programming examples, Panel is used in place of these values). These commands are case
insensitive.
Input Commands
^CAL
Put remote in
calibration mode.
Syntax:
"'^CAL'"
Example:
SEND_COMMAND Device,"'^CAL'"
Puts the remote in calibration mode.
Panel Setup Commands
^MUT
Set the panel
mute state
Syntax:
SEND_COMMAND <DEV>,"'^MUT-<mute state>'"
Variables:
• mute state = 0 = Mute Off and 1 = Mute On.
Example:
SEND_COMMAND Device,"'^MUT-1'"
Sets the panel's master volume to mute.
@PWD
Set the page flip
password
@PWD sets the level 1 password only.
Syntax:
SEND_COMMAND <DEV>,"'@PWD-<page flip password>'"
Variables:
• page flip password = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Device,"'@PWD-Main'"
Sets the page flip password to 'Main'.
^PWD
Set the page flip
password
Password level is required and must be 1 - 4.
Syntax:
SEND_COMMAND <DEV>,"'^PWD-<password level>,<page flip password>'"
Variables:
• password level = 1 - 4.
• page flip password = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Device,"'^PWD-Main'"
Sets the page flip password on Password Level 1 'Main'.
^VOL
Set the panel
volume
Syntax:
SEND_COMMAND <DEV>,"'^VOL-<volume level>'"
Variables:
• volume level = 0 - 100. 100 is maximum volume setting.
Example:
SEND_COMMAND Device,"'^VOL-50'"
Set the panel volume to 50.